Accessories purchase core precautions
Suitability priority verification
Before purchasing accessories, carefully check the parameter requirements of the corresponding model to confirm that the size and performance parameters of the accessories fully match the original design standards of the equipment. Do not replace accessories that do not match the parameters at will to avoid interference with the original operating logic of the equipment and unnecessary failures. Before purchasing, you can check the codes one by one against the official accessories catalog of the equipment to reduce the situation of wrong purchases and missed purchases.
Quality screening points
After getting the accessories, you can first check the appearance and workmanship to confirm that the surface of the accessories is free of burrs and cracks, and the material identification is clear and compliant. Do not buy inferior accessories with rough workmanship to avoid parts breaking and failure during high-load operations, which affects the safety and efficiency of the operation.
Selection of compliance channels
Try to choose formal authorized procurement channels to obtain accessories, ensure that the full-link traceability of accessories can be checked, and timely after-sales treatment can be provided for quality problems. Do not choose unqualified scattered channels to reduce procurement costs and avoid subsequent operation and maintenance disputes.
Common wearing parts replacement guide
Conventional consumable parts replacement cycle
In daily use, regular inspections of commonly used wearing parts such as tires, brake pads, hydraulic seals, and filter elements should be carried out, and the loss rate should be judged based on the strength of the working conditions. Under normal working conditions, the recommended periodic investigation should be carried out according to the instructions for the use of the equipment. If there are abnormal conditions such as excessive wear, leakage, and blockage, replacement should be arranged in time, and failure should not be carried out continuously.
Replacement operation basic specification
Before carrying out the replacement operation of wearing parts, the forklift should be parked on a flat hard ground, the power supply of the whole vehicle should be disconnected, and protective measures such as fork landing and vehicle support should be taken to avoid equipment sliding or bumping due to misoperation. During the operation, follow the standard steps to gradually disassemble and install, and do not violently disassemble and damage the surrounding supporting parts.
Commissioning verification after replacement
After the installation of the accessories is completed, the no-load test operation should be carried out first, and the operation status of the core functions such as walking, braking, lifting, and steering should be tested one by one. After confirming that all functions are back to normal and there is no abnormal sound or leakage problem, the forklift should be arranged to be put into formal operation. The daily wear and tear of the accessories can be regularly recorded, and the commonly used wearing parts should be reasonably stocked to reduce the impact of operation stagnation caused by sudden failures.
