Electric forklifts are commonly used handling equipment in warehousing, logistics, manufacturing, and other scenarios. 2-ton lithium-ion forklifts are widely used due to their fast power response and stable battery life, but improper operation can easily lead to safety accidents, requiring strict compliance with regulations.
A comprehensive inspection is required before operation. In terms of appearance inspection, it is necessary to check whether the body has obvious bumps or deformations, whether the air pressure of the wheels is normal, whether the depth of the tire pattern meets the needs of operation, and whether the operating parts such as pedals, steering wheels, and seats are firm. When checking the power system, it is necessary to confirm whether the lithium battery power is sufficient, whether the battery interface is clean and not loose, whether the insulating layer is intact, whether the instrument panel display is normal, and whether the fault indicator light is on. If the power is insufficient or there is a fault prompt, it needs to be dealt with in time before use. Safety device inspection is particularly critical. It is necessary to test the sensitivity of the braking system, including the driving brake and parking brake. Check whether the warning lights, horns, and reflectors are working normally. Ensure that the seat belt can be fastened and lifted normally
Pay attention to stability and norms during driving. Before starting the vehicle, fasten the seat belt, adjust the gear to neutral, confirm that there are no people or obstacles around, and then sound the horn to signal the start. When driving, maintain a stable speed, avoid rapid acceleration, sudden braking or sharp steering wheel, especially in turns, narrow passages, ramps or areas with water and oil stains on the ground, slow down in advance, and sound the horn again if necessary. When carrying goods, the center of gravity of the goods should fall within the bearing range of the forklift, try to reduce the height of the fork, keep the fork 10 to 20 cm from the ground, and the door frame is properly tilted back to enhance driving stability and avoid the shaking or falling of the goods. When meeting a car, you should take the initiative to slow down, choose a safe position to avoid, ensure a sufficient safe distance from other vehicles or personnel, and strictly prohibit overtaking.
When loading and unloading goods, it is necessary to operate strictly according to the requirements. Before loading and unloading, it is necessary to confirm whether the weight and volume of the goods are within the rated range of the 2-ton lithium battery forklift. Overloading operations are strictly prohibited, and partial loading is not allowed. The goods should be evenly placed on the fork. The spacing of the forks should be reasonably adjusted according to the size of the goods to ensure the stability of the goods. Before lifting the goods, adjust the position of the door frame so that the fork is in full contact with the pallet or the bottom of the goods, and then slowly lift to avoid shaking or sliding of the goods. When loading and unloading goods on the ramp, it is necessary to be careful and try to choose a flat area. If you must operate on the ramp, it is necessary to ensure that the vehicle brakes reliably and the center of gravity of the goods is
After the operation is over, follow-up matters cannot be ignored. It is necessary to park the vehicle in the designated safe area, pull up the parking brake, adjust the gear to neutral, turn off the power switch, and pull out the key. Clean up the debris on the body and wheels in a timely manner, and check the vehicle for new damage or abnormalities. If charging is required, it should be carried out in a dedicated charging area with good ventilation and away from flammable and explosive items. Strictly follow the operating instructions of the charging equipment. No unauthorized departure during the charging process.
